Ericsson LBI-39055 manual Software Installation and Upgrades, File Directories and Contents

LBI-39055

Data General 386SX/25A (Acer)

The set-up program is started by pressing <Ctrl><Alt><Esc> during the boot process. COM1 is disabled by selecting the "System Security Setup" and then setting "Serial Port1 Control" to "[Disable]". Press <Esc> twice to save the change and reboot.

Compaq 386S

This PC's set-up program is not used to disable the built-in COM1 port. Instead, COM1 is disabled by setting the main board's DIP switch SW2 positions 4 and 5 both "ON". Refer to the PC's documentation for additional details.

SOFTWARE INSTALLATION AND UPGRADES

As previously stated, all C3 Maestro application software is installed on the PC's hard disk drive at the factory. Refer to Ericsson GE document SRN-1000-xx which is included with a software upgrade package if a re- installation or an upgrade is necessary.

AUTOEXEC.BAT File Contents

Contents of the AUTOEXEC.BAT file located in the root directory (C:\) are as follows. Changes are not recommended:

@ECHO OFF PATH=C:\DOS;C:\UTIL PROMPT $P$G CD\CONSOLE

CONKEY

CONSOLE

CONFIG.SYS File Contents

Contents of the CONFIG.SYS file located in the root

directory (C:\) are as follows. Changes are not recommended:

FILES=20

BUFFERS=40

DEVICE=C:\DOS\ANSI.SYS

NOTE

Earlier consoles used a "BUFFERS=25" setting.

FILE DIRECTORIES AND CONTENTS

Table 12 specifies PC file directories and files directly applicable to the C3 Maestro console. The MS-DOS file directory and its files are not shown. Also, other utility files not listed in the table may exist in the utility directory which are not essential to the operation of the C3 Maestro application program.

TABLE 12 - C3 MAESTRO

PC FILE DIRECTORIES AND FILES

ROOT	CONSOLE	UTILITY
DIRECTORY	DIRECTORY	DIRECTORY
(C:\)	(C:\CONSOLE)	(C:\UTIL)

EDITOR PROGRAM

If necessary, the Editor program (EDITOR.EXE) can be used to change one or more or the following parameters (non-inclusive list):

∙Logic Board Interrupt (IRQ)

∙COM1 Serial Port Baud Rate

∙Set-Up Titles

∙Call Director ID

∙Boom/Gooseneck Mic Presence (version 2.x and previous only)

AUTOEXEC.BAT

CONFIG.SYS

COMMAND.COM*

IO.SYS*

MSDOS.SYS*

AUXIO.DAT

CONFIG.DAT

CONKEY.COM

CONSOLE.EXE

EDITOR.EXE

ENGLISH.DAT

ENTITY.DAT

FONT33.DAT

NORWEGAN.DAT

PHONE.DAT

SETUPS.DAT

CTEST.EXE

Except for the Call Director ID parameter, these parameters cannot be changed via the CEC/IMC Manager (MOM PC).

NOTE

CEC/IMC Manager (MOM PC) version 2.x (and earlier) also did not provide support for Call Director ID; this parameter also had to be set via the Editor program.

*MS-DOS V3.3 or greater. IO.SYS and MSDOS.SYS are hidden files.

19