Ericsson LBI-39128 manual Site Controller Hardware, Site Controller Software

Models: LBI-39128

1 38
Download 38 pages 31.25 Kb
Page 8
Image 8

LBI-39128

INSTALLATION

INSTALLATION

Access to the PROM card in previous VAX versions and older PDP versions that were upgraded to a VAX version is through the top using the following procedure:

SITE CONTROLLER HARDWARE

Verify that the Site Controller computer is a VAX model, or a PDP model that has been upgraded to a VAX model (see the VAX Site Controller heading in the Applications Notes section). If you find that the Site Controller computer is a PDP model, upgrade kits are available through Ericsson Service Parts. Alternatively, the PDP model may be replaced with the current 19A149302P9 VAX model.

SITE CONTROLLER SOFTWARE

The Site Controller computer contains a set of 14 Application Software PROMs and a set of two Personality PROMs. Both sets are located on the PROM card. Access to the PROM card in the latest VAX version of the Site Controller computer is through the back using the following procedure:

1.Turn off the Site Controller computer.

2.Loosen the two fastener screws holding the back panel to the chassis (see Figure 3).

 

31

30

29

28

 

 

 

 

 

 

Fastener

 

 

 

15

14

13

12

11

10

9

27

26

25

24

 

 

 

 

 

 

Screws

 

 

 

8

7

6

5

4

3

2

23

22

21

20

 

 

 

 

 

 

 

 

 

 

 

 

 

 

19

18

17

16

 

 

 

 

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

0 SM

 

Figure 3 - Location of Fastener Screws on Computer

3.Rotate the back panel down and out of the way (be careful not to damage the ribbon cables).

PROM Card

Figure 4 - Location of PROM Card in Computer

4.Remove the PROM Card (see Figure 4) by pulling on the two tabs fastened to the front edge of the card. (Observe standard handling practices for static sensitive components.)

1.Turn off the Site Controller computer.

2.Pull the Site Controller computer chassis all the way forward on its slide-out track.

3.Pull up the top cover and the attached card cage.

4.Remove the PROM Card (see Figure 5) by pulling on the two tabs fastened to the front edge of the card. (This is a three-handed operation - observe standard handling practices for static sensitive components.)

PROM Card

Figure 5 - Location of PROM Card in Older Computer

 

 

Personality

13

14

PROMs

01-02

01

02

 

09

10

 

11

12

 

05

06

Application

Software

07

08

PROMs

 

 

01-14

01

02

 

03

04

 

Figure 6 - Location of PROMs on PROM Card

8

Page 8
Image 8
Ericsson LBI-39128 manual Site Controller Hardware, Site Controller Software