Ericsson LBI-39128 manual Sentry PMU REV 8.6 12/07/94

LBI-39128 INSTALLATION

4.Type 8860 and press the Enter key. The Operation Select Menu should then appear on the terminal as shown in Figure 15 (revision # and date may be different). If the PMU does not respond to this entry, the password may have been re-configured from its factory default value. See the Erase All Programming heading in the Maintenance section for the procedure to return all parameters to the factory default values, including returning the password to 8860.

5.With the Operational Select Menu shown on the terminal, type 4 (for item #4 - Setup) and press the Enter key. The Setup Selection Menu should then appear on the terminal as shown in Figure 16.

6.With the Setup Selection Menu shown on the terminal, type 10 (for item #10 - Erase All Programming) and press the Enter key.

7.At the “Enter Y to Continue, Any Other Character to Abort:” prompt (after the warning message), type Y and press the Enter key.

8.At the “Enter Site Password” prompt, type 8860 and press the Enter key.

9.At the “Enter Site ID” prompt, type 1234 and press the Enter key. You will be given a 4-second countdown and then a flashing “Sentry Initialized” message.

10.Finally the Setup Selection Menu should appear on the terminal.

SENTRY 8860 COPYRIGHT 1987-1994 DECIBEL PRODUCTS PATENT 4,823,280

OPERATION SELECT MENU SENTRY PMU REV 8.6 12/07/94

1.DISCONNECT

2.REPORTS

3.MANUAL CONTROL

4.SETUP

5.HARDWARE STATUS

6.SOFTWARE STATUS

7. RESET ***WARNING - FOR EMERGENCY ONLY***

ENTER SELECTION:

Figure 15 - Operation Select Menu (Main Menu)

SETUP SELECTION MENU

1.RETURN TO OPERATION SELECT MENU

2.SITE DATA #1

3.SITE DATA #2

4.ANALOG INPUT CHANNEL

5.DIGITAL INPUT CHANNEL

6.ANALOG PSEUDO CHANNEL

7.DIGITAL PSEUDO CHANNEL

8.RELAY OUTPUTS

9.INPUT CONVERSION TABLE

10.ERASE ALL PROGRAMMING

11.db TEST CONFIGURATION

12.db TOWER LIGHTS CONFIGURATION

ENTER SELECTION: _

Figure 16 - Setup Selection Menu

16