Euphonix MC Control - page 28

professional control surface

Artist Series

USER GUIDESURFACE CONTROLS

28

The MC Control has four channel strips each with a touch-sensitive fader, eight

touch-sensitive knobs surrounding a 7-in touchscreen, twelve soft keys, trans-

port switches, a Jog wheel, and various navigation buttons.

The MC Control comes with an external DC power supply. Rear panel jacks in-

clude: DC power input, RJ-45 Ethernet, and ¼-in footswitch.

4.1 Power Switch

Press and release the POWER switch to turn the MC Control on/off.

• The Touchscreen shows a Euphonix logo upon power up.

• All activity on the Touchscreen ceases upon power down.

4.2 Shift Key

The Shift key is used in conjunction with other keys to access the functions la-

beled in blue above the primary function. Press and hold the Shift key, found at

the MC Control’s bottom-left and -right, then press the other key.

The User Guide uses the following simplified terminology to describe Shift func-

tions: “press the Shift + APPLICATION keys” is written as “press the WORKSTATION

key.”

The Shift key can be locked on like caps lock on a computer keyboard by press-

ing both Shift keys simultaneously. This is useful if you plan to access several

Shift functions consecutively. Press either Shift key to unlock.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls viii Chapter 5: Touchscreen and Controls Chapter 6: EuControl ix Appendix A: Setting the IP Address Page USER GUIDELIST OF FIGURES xi List of Figures Page INTRODUCTION TO THE ARTIST Chapter 1: Introduction to the Artist EuControl Software INTRODUCTION TO THE ARTIST Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Control 2.1.1 Elevating the MC Control 2.1.2 Physically Linking Artist Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls MC CONTROL Shift key Fader Strips Power switch STOP Page 4.3 Fader Strips 4.3.1 Fader 4.3.2 ON Page 4.4 Navigation Controls 4.4.1 BANK and NUDGE Window 1234567891011 141312 15 16 Tracks Strips 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 APPLICATION 4.4.5 WORKSTATION 4.4.6 Navigating Among Multiple Artist Devices 4.5 Knobs 4.5.1 Knob Set Selection Page 4.5.2 Knob Functions 4.5.3 Knob Set Navigation Keys Page 4.6 Soft Keys 4.7 Jog Wheel and Transport Controls 4.7.1 Jog Wheel Functions 4.7.2 Transport Controls Page Chapter 5: Touchscreen and Controls Page Page 5.3 Setup Screens 5.3.1 Control Room 5.3.2 Monitor Page Chapter 6: EuControl 6.1 Surfaces Page Page Page Page Page Page 6.4.3 MC Control Display Page Page Page Appendix A: Setting the IP Address