Euphonix MC Control 5.3.2 Monitor

professional control surface

Artist Series

USER GUIDETOUCHSCREEN AND CONTROLS

Dim: Dims the control room volume (lit when dim is active).

Cut: Mutes the control room volume (lit when cut is active).

5.3.2 Monitor

The Monitor Touchscreen selects the source of the monitor volume knob or

mutes monitor A. Holding down the Shift key and turning the control room knob

changes the volume of Monitor A in Studio Monitor Express or the attached ap-

plication if it supports a EuCon monitor section.

Figure 5-5 Setup: Monitor

Monitor Source: Lists the possible sources to the monitor volume control. The

TS arrow buttons scroll through sources if there are more than four. Touching

one of the sources highlights it and makes it the current monitor source.

Cut: Mutes the monitor volume (lit when cut is active).

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls viii Chapter 5: Touchscreen and Controls Chapter 6: EuControl ix Appendix A: Setting the IP Address Page USER GUIDELIST OF FIGURES xi List of Figures Page INTRODUCTION TO THE ARTIST Chapter 1: Introduction to the Artist EuControl Software INTRODUCTION TO THE ARTIST Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Control 2.1.1 Elevating the MC Control 2.1.2 Physically Linking Artist Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls MC CONTROL Shift key Fader Strips Power switch STOP Page 4.3 Fader Strips 4.3.1 Fader 4.3.2 ON Page 4.4 Navigation Controls 4.4.1 BANK and NUDGE Window 1234567891011 141312 15 16 Tracks Strips 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 APPLICATION 4.4.5 WORKSTATION 4.4.6 Navigating Among Multiple Artist Devices 4.5 Knobs 4.5.1 Knob Set Selection Page 4.5.2 Knob Functions 4.5.3 Knob Set Navigation Keys Page 4.6 Soft Keys 4.7 Jog Wheel and Transport Controls 4.7.1 Jog Wheel Functions 4.7.2 Transport Controls Page Chapter 5: Touchscreen and Controls Page Page 5.3 Setup Screens 5.3.1 Control Room 5.3.2 Monitor Page Chapter 6: EuControl 6.1 Surfaces Page Page Page Page Page Page 6.4.3 MC Control Display Page Page Page Appendix A: Setting the IP Address