Euphonix MC Control 6.1 Surfaces

professional control surface

Artist Series

USER GUIDEEuControl

6.1 Surfaces

The Surfaces tab shows all Artist devices on your network and those connected to

your instance of EuControl.

Figure 6-2 Surfaces tab

All Surfaces

All Surfaces shows all Artist devices on the network. A device shown in light gray

is already connected either to your own or another instance of EuControl run-

ning on a different workstation. In both cases, it is not selectable.

My Surfaces

My Surfaces shows the Artist devices connected to your instance of EuControl.

There can be one MC Control and up to four MC Mixes in the My Surfaces list,

linked into a single large surface.

The top-to-bottom order corresponds to the left-to-right order of the surfaces,

respectively. The leftmost surface has fader strip 1. Use the and buttons

to reorder the list.

Each Artist device can be renamed by double-clicking the existing name and typ-

ing a new name.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls viii Chapter 5: Touchscreen and Controls Chapter 6: EuControl ix Appendix A: Setting the IP Address Page USER GUIDELIST OF FIGURES xi List of Figures Page INTRODUCTION TO THE ARTIST Chapter 1: Introduction to the Artist EuControl Software INTRODUCTION TO THE ARTIST Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Control 2.1.1 Elevating the MC Control 2.1.2 Physically Linking Artist Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls MC CONTROL Shift key Fader Strips Power switch STOP Page 4.3 Fader Strips 4.3.1 Fader 4.3.2 ON Page 4.4 Navigation Controls 4.4.1 BANK and NUDGE Window 1234567891011 141312 15 16 Tracks Strips 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 APPLICATION 4.4.5 WORKSTATION 4.4.6 Navigating Among Multiple Artist Devices 4.5 Knobs 4.5.1 Knob Set Selection Page 4.5.2 Knob Functions 4.5.3 Knob Set Navigation Keys Page 4.6 Soft Keys 4.7 Jog Wheel and Transport Controls 4.7.1 Jog Wheel Functions 4.7.2 Transport Controls Page Chapter 5: Touchscreen and Controls Page Page 5.3 Setup Screens 5.3.1 Control Room 5.3.2 Monitor Page Chapter 6: EuControl 6.1 Surfaces Page Page Page Page Page Page 6.4.3 MC Control Display Page Page Page Appendix A: Setting the IP Address