Euphonix MC Control

professional control surface

Artist Series

USER GUIDEEuControl

6.3 General

This tab controls how the Artist device and application software work together.

Figure 6-4 General tab

6.3.1 Workstation tracks knob set changes

The workstation is aware of which knobset is selected and displays appropriate

controls.

6.3.2 Open plug-ins on workstation when editing

When a plug-in knobset is selected on the MC Control, the workstation opens

the plug-in’s window.

6.3.3 Close plug-ins on workstation when editing

When a plug-in’s knobset is navigated from on the MC Control, the workstation

closes the plug-in’s window.

6.3.4 Select by Touch

Touching an MC Control fader selects that track in the application and attentions

it on the MC Control. This is the same as pressing the fader SEL key.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls viii Chapter 5: Touchscreen and Controls Chapter 6: EuControl ix Appendix A: Setting the IP Address Page USER GUIDELIST OF FIGURES xi List of Figures Page INTRODUCTION TO THE ARTIST Chapter 1: Introduction to the Artist EuControl Software INTRODUCTION TO THE ARTIST Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Control 2.1.1 Elevating the MC Control 2.1.2 Physically Linking Artist Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls MC CONTROL Shift key Fader Strips Power switch STOP Page 4.3 Fader Strips 4.3.1 Fader 4.3.2 ON Page 4.4 Navigation Controls 4.4.1 BANK and NUDGE Window 1234567891011 141312 15 16 Tracks Strips 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 APPLICATION 4.4.5 WORKSTATION 4.4.6 Navigating Among Multiple Artist Devices 4.5 Knobs 4.5.1 Knob Set Selection Page 4.5.2 Knob Functions 4.5.3 Knob Set Navigation Keys Page 4.6 Soft Keys 4.7 Jog Wheel and Transport Controls 4.7.1 Jog Wheel Functions 4.7.2 Transport Controls Page Chapter 5: Touchscreen and Controls Page Page 5.3 Setup Screens 5.3.1 Control Room 5.3.2 Monitor Page Chapter 6: EuControl 6.1 Surfaces Page Page Page Page Page Page 6.4.3 MC Control Display Page Page Page Appendix A: Setting the IP Address