Euphonix MC Control

professional control surface

Artist Series

USER GUIDETOUCHSCREEN AND CONTROLS

Menu Bar: Displays the Tracks view, Soft Key view, or Setup Screens on the

Touchscreen. The center of the screen changes to reflect the selected Menu

view.

5.1 Tracks View

Tracks view shows 32 tracks at a time so it allows quickly muting, soloing, arm-

ing, and selecting tracks that are not assigned to the faders.

Figure 5-2 Track View

Select an operation on one of the four circular buttons on the left and then touch

one or more of the square track buttons to perform that operation on the select-

ed tracks. Touch a selected track button again to deselect it.

Solo: A yellow circle surrounding an “S” on the lower left of the track rectangle

shows the track is soloed.

Rec: A red circle around the track number in the lower right shows the track is

armed to record.

Contents

Main ii Communications and Safety Regulation Information Page iv IMPORTANT SAFETY INSTRUCTIONS v Page vii Table of Contents List of Figures Chapter 1: Introduction to the Artist Chapter 2: Setup and Installation Chapter 3: Common Tasks Chapter 4: Surface Controls viii Chapter 5: Touchscreen and Controls Chapter 6: EuControl ix Appendix A: Setting the IP Address Page USER GUIDELIST OF FIGURES xi List of Figures Page INTRODUCTION TO THE ARTIST Chapter 1: Introduction to the Artist EuControl Software INTRODUCTION TO THE ARTIST Conventions Used in this User Guide How to Use the PDF Chapter 2: Setup and Installation 2.1 Setting Up the MC Control 2.1.1 Elevating the MC Control 2.1.2 Physically Linking Artist Devices Page 2.2 Installation Page Controlling a Second Workstation Page Page Chapter 3: Common Tasks Page Page Page Artist Series Chapter 4: Surface Controls MC CONTROL Shift key Fader Strips Power switch STOP Page 4.3 Fader Strips 4.3.1 Fader 4.3.2 ON Page 4.4 Navigation Controls 4.4.1 BANK and NUDGE Window 1234567891011 141312 15 16 Tracks Strips 4.4.2 MIXER and CLOSE 4.4.3 HOME and END 4.4.4 APPLICATION 4.4.5 WORKSTATION 4.4.6 Navigating Among Multiple Artist Devices 4.5 Knobs 4.5.1 Knob Set Selection Page 4.5.2 Knob Functions 4.5.3 Knob Set Navigation Keys Page 4.6 Soft Keys 4.7 Jog Wheel and Transport Controls 4.7.1 Jog Wheel Functions 4.7.2 Transport Controls Page Chapter 5: Touchscreen and Controls Page Page 5.3 Setup Screens 5.3.1 Control Room 5.3.2 Monitor Page Chapter 6: EuControl 6.1 Surfaces Page Page Page Page Page Page 6.4.3 MC Control Display Page Page Page Appendix A: Setting the IP Address