EuroLite Cases 4-channel DMX dimmer pack, EDX-4 user manual Operation, Cleaning and Maintenance

Occupation of the DIP-switches:

Setting the DMX-	DIP-switch no.	1	2	3	4	5	6	7 8 9
starting address:
Device number	Starting address	1	2	4	8	16	32	64 128 256
& channels
	On
Device 1 - channel 1
	Off
	On
Device 2 - channel 2
	Off
	On
Device 3 - channel 3
	Off
	On
Device 4 - channel 4
	Off

On

Device 5 - channel 5

Off

Setting the DMX-		DIP-switch no. 1		2	3	4	5	6	7 8 9
starting address:
Projector number		DMX-starting	1	2	4	8	16	32	64 128 256
& channels		address
Device 1		On
	- channels 1-4
		Off
Device 2		On
	- channels 5-8
		Off
Device 3		On
	- channels 9-12
		Off
		On
Device 4	- channels 13-16
		Off

On

Device 5 - channels 17-20

Off

This device can be defined as a 4-channel dimmer pack (normal DMX) or as with one address for all 4 channels (DMX parallel).

Please adjust your selection via DIP-switch no. 10.

DIP-switch 1: one address

DIP-switch 0: 4 channels

FUNCTION

DMX ADDRESS

1 2 4 8 16 32 64 128 256 Function

1	2	3	4	5	6	7	8	9	10
any one of DIP switch 1-9 is on, DMX parallel									1

All of DIP switch 1-9 is off, auto parallel

any one of DIP switch 1-9 is on ,DMX

0

All of DIP switch 1-9 is off , Auto

6. OPERATION

After you connected the device to the mains and switched the circuit breaker, the EDX-4 is ready for use.

You can control the desired channel via you lighting controller. When a DMX-controller and an analog controller is connected, the device reacts to the stronger signal.

7. CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an expert after every four years in the course of an acceptance test.

The operator has to make sure that safety-relating and machine-technical installations are inspected by a skilled person once a year.

The following points have to be considered during the inspection:

1)All screws used for installing the devices or parts of the device have to be tighly connected and must not be corroded.

2)There must not be any deformations on housings, fixations and installation spots (ceiling, suspension, trussing).

3)The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments. Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems have to be removed.

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!

21/40 70064072_V_2_2.DOC