EverFocus EDR410H, EDR810H, EDR810M, EDR410M instruction manual VIDEOLOSS Setup Menu, Videoloss, Log

3.6 VIDEOLOSS Setup Menu

Diagram 3.9

Diagram 3.9 is a screen shot of the VIDEOLOSS SETUP MENU. VIDEOLOSS event is caused when no video signal input is detected on a channel. Usually it happens when the camera loses power or the camera fails. In the VIDEOLOSS SETUP MENU the following fields are defined as follows:

1.VIDEOLOSS:

ENABLE: Enable video loss detection.

DISABLE: Disable video loss detection.

2.LOG:

ON: Select ON if you wish to record Video Loss Events in the Log.

OFF: Select OFF if you do not wish to record Video Loss Events in the Log.

3.DURATION: The amount of time a Video loss event will record - from 1 sec to 99 seconds. The default value is 5 seconds. To change this, simply use the Jog Dial on the DVR.

4.ALARM OUTPUT: This will transmit a signal to another device. The setting of alarms are NONE = not activated, 1 = output signal 1 transmitted. To change this, simply use the Jog Dial on the DVR.