Alarm: Select the alarm input trigger connection number from 1 to 12.

Enable: Check box to enable response to that alarm trigger.

Input Type: This field is to change the type of alarm trigger. N.O.: Normal Open contact.

N.C.: Normal Closed contact.

Display Switch: Select which channel to be displayed when alarm is triggered. Available options are CH1~12, Quad 1, Quad 3 and Quad 3.

Alarm Output: This will transmit a signal through the alarm output. It can be set to either “NONE” (not active), “1” or “2” (selects alarm relay to be active).

Output Type: Output action when alarm is triggered. Timeout: Alarm output lasts for the set time duration.

Permanent: Alarm will remain active until the user presses the “Enter” key or resets the alarm remotely.

Transparent: Alarm output remains as long as the alarm input is active.

Trans+Timeout: Alarm output continues until event ends, then continues for the set time duration. Timeout Duration: Time duration selectable from 1 to 150 seconds.

Pre-alarm Record: Check box to start copying recorded video to the hard disk from 5 seconds before the alarm event. (Pre-alarm recording rate will follow the “Normal” frame rate setting)

Buzzer: Check this box to enable the buzzer when an alarm occurs.

Email: Check box to enable email notification when an alarm occurs. Email operation requires that valid email settings have been entered in the Network Setting/Email setup screen. (See Section 4.7.4 Email for more information.)

Network Alarm: Check this box to send out a network alarm to a client PC when motion occurs. (This feature requires PowerCon software on the client PC and proper settings for the Alarm Server in the Network Setup menu; see Section 4.7.6 Alarm Server for more information.)

Click button to return to the previous level of menu.

42

Page 50
Image 50
EverFocus EMV1200 user manual