Note: In order to protect the bulb from dirt and scrape, please put on the gloves before installing the bulb.
7. Turn on the power, and start to operate the EPTZ3000.
Note: When turning on the power, EPTZ3000 will enter
2.4.3. EPTZ3000I Dome Camera Installation
1.Take off the housing from the packing, and take off the PCB board (4 bolts on it) inside the housing.
2.Cut the ceiling against the housing’s shape with a saw.
The exact diameter for cutting circle is 202 mm. It cannot exceed 213 mm, because speed dome housing may across the ceiling without any support. Please leave a profound space of 144.5 mm, so that the housing can be perfectly inserted to the ceiling.
3.Thread the cable through the screw and the hole on the top of the housing, and tighten up the screw to fix the cable
4.Place the housing into the hole that you just made. Fix the housing on the ceiling with two clips, adjust the screws of clips to make the housing perfectly fit to the ceiling.
5.Connect the cable connectors to the nodes on the base board, and then fix the base board in the housing by screwing 4 bolts on it.