Everpure SID650A, 80 manual Maintenance, Cleaning Instructions, Ice Maker Section

Models: 80 SID650A

1 41
Download 41 pages 50.53 Kb
Page 18
Image 18
MAINTENANCE

MAINTENANCE

It is recommended that the air inlet filter be cleaned ever 3 months or sooner, depending on the operating envi- ronment for proper refrigeration system performance. On air-cooled units. also check that the condenser is free of dirt/foreign material that could cause air flow blockage. Consult the MAINTENANCE/ADJUSTMENT PROCE- DURES for cleaning these items.

Cleaning of the icemaker is recommended on a regular basis not only for sanitary reasons but also to maintain the performance of the unit. Build-up of lime and scale can hinder icemaking production rates and interfere with proper dispensing of the ice. See the CLEANING SECTION for the recommended procedure.

periodically, check the vending area sink for proper water drainage. Remove any foreign material from the sink to prevent drain blockage.

CLEANING INSTRUCTIONS

IMPORTANT: The icemaker should be cleaned at a minimum of 3 month intervals or more frequently, depending on local water conditions. The storage hopper interior should be cleaned at least once a month.

WARNING: Do not use metal scrapers, sharp objects or abrasives on the surface of the storage hopper, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic surface. Use only recommended chemicals and solutions for

both the icemaker and hopper.

Ice Maker Section

1.Open the hinged service door on the upper left side panel.

2.Put the stop/run switch in the “stop”position at the end of the harvest cycle. An alternate method would be to stop the unit during the icemaking cycle and allow ice in the evaporator to melt by waiting for at least 1 hour before beginning the cleaning procedure. The “Flush”switch can be depressed to bring in warmer wa- ter help the melting process.

WARNING: Electrical power is on to unit during icemaker section cleaning. To avoid possible injury doe not reach into hopper or into icemaker nozzle. Do not contact exposed electrical wiring and components.

3.Close the water supply valve to the ice maker.

4.Remove the ice drop cover from evaporator and the storage hopper cover.

5.Seal the evaporator outlet with the plastic plug provided with the unit and replace the ice drop cover.

6.Move the water float valve reservoir to the “Clean”position by lifting slightly and pulling forward to raise the reservoir to the upper mounting screws.

7.Remove the float valve cover and add 4 ounces of Virginia Ice Machine Cleaner to the reservoir.

CAUTION: Virginia Ice Machine Cleaner is a mild acid. Normal care should be taken - keep out of eyes and cuts. Read warnings on package before using. Do not operate unit in the cleaning mode without the ice drop cover in place. There may be some overflow of

cleaning solution through the evaporator vent tube during the cleaning cycle.

90846

14

Page 18
Image 18
Everpure SID650A, 80 manual Maintenance, Cleaning Instructions, Ice Maker Section