8.Open the water supply valve and fill evaporator with water (level is up in float reservoir).
9.Put the clean/run switch in the “clean”position. Allow unit to run in the cleaning mode for at least 30 min- utes.
10.Put the clean/run switch in the “run”position.
11.Close the water supply valve.
12.Depress the “Flush”switch push button and drain evaporator for about
13.Close water supply valve. Depress the “Flush”switch push button for 1 1/2 minutes to drain the evaporator.
14.Lower float valve reservoir to “Run”position. Remove the evaporator plug.
15.Open the water supply valve and fill the evaporator with water.
16.Put the “Stop/Run”switch in the “run”position and allow unit to run through at least 3 complete ice making cycles and until ice is free of “sweet”taste.
WARNING: If unit fails to harvest, put the stop/run switch in the “stop” position. Close the water supply valve. Depress the “Flush” switch push button for 1 1/2 minutes to drain the evaporator. Flush the evaporator with hot water to melt remaining ice. Repeat step 12, to
remove all traces of the cleaning solution from the evaporator.
17. Dispense all ice out of storage hopper and discard.
Dispenser Section
1.Turn off main electrical power supply to machine.
2.Remove agitator assembly from storage hopper and wash and rinse it thoroughly.
3.Wash down all inside surfaces of the ice storage area including the top cover and ice drop cover with a mild detergent solution, and rinse thoroughly to remove all traces of detergent.
4.Replace agitator.
5.Remove ice chute cover as follows:
A.Flex sides outward to disengage lower pins.
B.Lift Ice Chute Cover to disengage upper pins.
C.Lower Ice Chute Cover down out of unit. Note. it may be helpful to twist cover slightly.
6.Clean the inside of the Ice Chute and Ice Chute Cover with a mild detergent solution and rinse thoroughly to remove all t races of detergent.
7.Reverse step above to reassemble ice chute.
8.Sanitize the inside of the hopper, agitator, ice chute and the hopper and ice drop covers with a solution of
(1) ounce of household bleach in two (2) gallons of water. (200 PPM).
9.Replace the hopper cover and ice drop cover. Turn on the electrical power supply. The icemaker is ready for normal operation.
FOR UNITS WITH BEVERAGE SYSTEM
Cold Plate
1. Carefully remove the lower front panel.
15 | 90846 |
