6Functional Specifications

Power Specifications

This section lists the power specifications for the tape drive.

Voltages

The tape drive operates from standard +5 VDC and +12 VDC supply voltages, as specified in Table 6-7.All specified voltages are DC; no external AC power is used by the tape drive. The tape drive does not provide any overvoltage or overcurrent protection.

Table 6-7Power specifications for standard voltages

Power specification

+5 Volts

 

+12 Volts

 

 

 

 

Nominal tolerance:

 

 

 

Ripple and Noisea

± 5% 125 mVpp max

(60Hz to 20 MHz)

 

 

 

 

 

 

 

Operating current:

 

 

 

Nominalb

 

 

 

SLDS cardc

1.7A

 

0.6A

SLDD cardc

2.1A

 

0.6A

Peakd

 

 

 

SLDS card

2.8A

 

1.6A

SLDD card

3.2A

 

1.6A

 

 

 

 

Operating power consumption:

 

14.5 watts

SLDS card

 

 

16.5 watts

SLDD card

 

 

 

 

 

 

 

 

Power consumption when idle:

 

13.0 watts

SLDS card

 

 

14.5 watts

SLDD card

 

 

 

 

 

 

 

 

aThe ripple voltage is included in the total voltage tolerance.

bNominal current occurs during streaming write or read operation.

cThe SLDS card is the single-ended card; the SLDD card is the differential card.

dThe peak current occurs during load, unload, or at the start of search or rewind operations, and lasts for less than 1.5 seconds.

Safety agency certification requires that the supplied voltages be from a Safety Extra-Low Voltage source (per IEC 950).

6-12

EXB-8205 and EXB-8505

510504

 

(Standard and XL)

 

Page 104
Image 104
Exabyte EXB-8505 8mm manual Power Specifications, Voltages, 7Power specifications for standard voltages