Extreme Networks 10018 manual LR4 QSFP+ Module, Install a QSFP+ Module

QSFP+ Modules

•

•

•

•

•

•

BlackDiamond X8 switch

BlackDiamond 8900-40G6X-xm I/O module

SummitStack-V80 stacking module installed in a Summit X460 series switch VIM2-SummitStack-V80 module installed in a Summit X480 series switch VIM3-40G module installed in a Summit X650 series switch

VIM4-40GX module installed in a Summit X670V-48x switch

For technical specifications for the QSFP+ module, see Technical Specifications.

LR4 QSFP+ Module

The LR4 QSFP+ module provides a 40-Gbps optical connection using LC optical connectors. This optical module integrates four data lanes in each direction with 40 Gbps aggregate bandwidth. Each lane can operate at 10.3125 Gbps up to 10Km using single mode fiber. The LR4 QSFP+ module conforms to the 802.3ba (40GBASE-LR4) standard.

The LR4 QSFP+ module is supported in the following Extreme Networks switches and components:

•

•

•

•

•

•

BlackDiamond X8 switch

BlackDiamond 8900-40G6X-xm I/O module

SummitStack-V80 stacking module installed in a Summit X460 series switch VIM2-SummitStack-V80 module installed in a Summit X480 series switch VIM3-40G module installed in a Summit X650 series switch

VIM4-40GX module installed in a Summit X670V-48x switch

For technical specifications for the QSFP+ module, see Technical Specifications.

Install a QSFP+ Module

You can install or remove QSFP+ modules in your switch without powering off the system.

Warning

QSFP+ modules contain Class 1M lasers. Invisible laser radiation can occur when laser connections areunplugged. Do not stare into the beam. This device is compliant with IEC 60825-1 Amendment 2 and CFR21Section 1040.

1Remove the QSFP+ module from its antistatic container and remove the dust covers from the module optical connector.

If your module has a protective pad covering the card-edge connector, remove it. Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location from which they can be easily retrieved if you need to uninstall the module.

2Remove any rubber dust covers from the port where you are installing the QSFP+ module.

3Holding the QSFP+ module by its sides, insert the QSFP+ module into the port on the switch or module.

Pluggable Hardware Installation Guide 27