Extreme Networks CFP2 modules

5Rotate the handle down 90 degrees to the closed position to secure the CFP2 module in the chassis. The handle should be flush against the front to the module.

Figure 23: Installed CFP2 Module (BlackDiamond X8 series switch)

If you are installing only one CFP2 module, make sure that all unoccupied ports are covered with a rubber dust cover.

Removing a CFP2 Module

You can remove a CFP2 module from your Extreme Networks switch without powering off the system.

Note

Disconnect fiber-optic cable from a CFP2 module before removing the CFP2 module from the port.

1Rotate the handle (bail latch) on the CFP2 module upward. Be sure that you rotate the bail latch up the full 90 degrees. The open position is perpendicular to the closed position..

2Pull the connector out of the port.

Pluggable Hardware Installation Guide

52

Page 52
Image 52
Extreme Networks 10018 manual Removing a CFP2 Module, Installed CFP2 Module BlackDiamond X8 series switch