Extron electronic 42-122-xx Track, Cut aluminum base track, Measure and cut track, Installation

Installation

Step 3: Track

3-1Measure and cut the track pieces to the desired length.

NIf the track is to be cut, the base track must be 10” (25.4 cm) longer than the cover track. This is the length of the connectivity box, which sits on the base track but not on the cover track (see figure below right).

The end ramps will add an additional 9.36”
(23.8 cm) to the total length of the installed track.
The track should run up to but not enter the hole in
the wall.	Cut aluminum base track
		10.00"
		(25.4 cm)
		Connectivity (AAP) Box
			Rubber Strip
			Aluminum
		7'-2"	Cover Track
	End Ramp	(2.184 m)
			Side Ramp
	9.36"
	(23.77 cm)
	8'-0"
	(2.438 m)

Measure and cut track

AVTrac • Installation 9