Mate side ramp to base track

3-4Lay the base track on the floor in the prepared location.

Mate the tabs in the side ramps with the grooves in the base track, and place the end ramps in position at the end of the track furthest from the wall.

Tab on side ramp mates with groove in base track.

Side Ramp

Base Track

3-5Using the provided 5/32" masonry bit, drill

1 1/2" (3.8 cm) deep pilot holes into the concrete through the predrilled mounting holes in the track and ramps.

Drill a 5/32” x 1 1/2” deep hole into concrete.

Supplied Masonry Screws

Drill into concrete and screw down track

3-6With the provided masonry screws, secure the track and ramps to the floor.

NDo not use the holes that were drilled to secure the connectivity box in step 3-3.

Screw side ramps to floor

AVTrac • Installation

Page 13

Image 13

Extron electronic 42-122-xx manual Mate side ramp to base track, Drill into concrete and screw down track

Contents

AVTrac Installation Guide Safety Instructions English PrecautionsConsignes de Sécurité Français Sicherheitsanleitungen Deutsch Overview IntroductionAVTrac Floor System Kit Contents Kit Contents Planning Before Getting StartedFloor Considerations In-Wall Cable Routing Considerations Room Considerations Wheelchair AccessibilityAVTrac maximum slope is Before Getting Started, cont’d Tools and Equipment Required for Installation Floor InstallationRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concrete Wall Cut cable access hole in wallMark wall Cut aluminum base track TrackMeasure and cut track Pre-drill holes in track and ramps Track, cont’dPositions of mounting holes Pre-drill holes to secure connectivity box Drill into concrete and screw down track Mate side ramp to base trackScrew side ramps to floor Secure connectivity box to the floor Connectivity Box Connect wires to AC receptacle Power Module Attach AC power module Power Module cont’dConnect double isolated cable to junction box Connect AC conduit to junction box AAPs Install AAPsRun cable to AAPs Ensure cables lay flat Finishing UpFit cover track Cut carpet Use template to cut base board Reattach base board to wall Refit carpetAttach carpet tile to track raceway Finishing up cont’d AVTrac installed Reference Material Specifications AVTrac 480R Cont’d Connectivity box USA Universal AC Compatibility Guide Track Accessories Optional AccessoriesActive AAPs Passive AAPs Reference Material Extron’s Warranty Before Getting Started Quick Installation Checklist

Extron electronic 42-122-xx manual Mate side ramp to base track, Screw side ramps to floor

Models: 42-122-xx