Extron electronic 42-122-xx manual Power Module cont’d, Attach AC power module

Installation Step 5: Power Module cont’d

5-2The AC power module must be positioned under the triple AAP socket that is closest to the track. Seat the power module on the stud in the connectivity box.

Slide the power module side tabs into the slots on the side of the connectivity box.

Secure the module to the stud on the connectivity box by hand tightening the provided 6/32" nut.

NThe illustration at right shows the Central European AC power module. Australian, French, and Universal models are also available.

AC Power	Tabs
Module

Studs

Slots

Attach AC power module

5-3Extron recommends the circuit be attached to a junction box that is directly wired to the main circuit. The AC power module does not have a fuse and is rated at 10 A, maximum.

Feed the fish tape from the junction box, through the wall cavity or raceway to the point where the AC conduit or double insulated cable from the AVTrac enters the wall or raceway.

Attach the end of the conduit or cable securely to the hook on the fish tape and rewind the tape, drawing

the cable behind it. If necessary, one person can feed Run AC conduit through wall cutout the conduit or cable into the wall or channel while a

second pulls the fish tape from the other end. Connect the wires as shown in the figures below:

To 10 Amp

Main Circuit To 10 Amp

Conduit

Main Circuit

	Conduit
Junction Box
	Junction Box
Blue/Black
(neutral)	Blue/Black
	(neutral)
Brown/Red	Brown/Red
(live)	(live)

	Green/Yellow	Green/Yellow
	(ground)
		(ground)
Cable
restraint	Double insulated	Cable/AC Conduit
	AC cable

From AVTrac AC

Power Module

Connect double isolated cable to junction box

From AVTrac AC

Power Module

Connect AC conduit to junction box

14AVTrac • Installation