Manuals / Extron electronic / Computer Equipment / Network Card

Extron electronic 42-122-xx Finishing Up, Ensure cables lay flat, Fit cover track, Cut carpet

Models: 42-122-xx

1 28

Download 28 pages 37.48 Kb

Page 18

Image 18

Installation

Step 7: Finishing Up

At this point, the track and connectivity box must be secured to the floor, the electrical power must be connected, and the AAP sockets must be populated.

To complete the installation of the AVTrac, follow these instructions:

7-1Lay the cables and power cords flat against the base track. If necessary, feed excess cable back into the wall.

Ensure cables lay flat

7-2Snap the cover track onto the base track.

Fit cover track

7-3Before cutting and gluing carpet, remove all dust and debris with a vacuum cleaner.

Cut the carpet or carpet tiles so that they run up to but do not cover the aluminum track (see the diagram below).

NCut the carpet to abut the edge of the cover track. Do not align the cuts to the edge of the ramps as this will leave a gap between the end of the carpet and the cover track.

Cut carpet

Carpet covers ramps but not track.

AVTrac • Installation

Page 18

Image 18

Extron electronic 42-122-xx manual Finishing Up, Ensure cables lay flat, Fit cover track, Cut carpet, Installation

Contents

AVTrac Installation GuideConnectivity for A/V, Data, and Power International/Universal ModelsConsignes de Sécurité Français PrecautionsSafety Instructions English Sicherheitsanleitungen DeutschOverview Wheelchair AccessibleIntroduction AVTrac Floor SystemChecklist for contents of box Kit ContentsCheck the contents of each box to ensure all items are present 2 AVTrac Kit ContentsCheck the contents of each box to ensure all items are present AVTrac Kit ContentsKit Contents Checklist for contents of boxFloor Considerations Before Getting StartedPlanning In-Wall Cable Routing ConsiderationsThe AVTrac maximum slope is Wheelchair AccessibilityRoom Considerations AVTrac Before Getting StartedTools Tools and Equipment Required for InstallationBefore Getting Started, cont’d Equipment/otherStep 1 Floor InstallationAVTrac Installation New ConstructionStep 2 Wall Cut cable access hole in wall8 AVTrac Installation Mark wallMeasure and cut track Step 3 TrackCut aluminum base track InstallationPre-drill holes in track and ramps 10 AVTrac InstallationStep 3 Track, cont’d Positions of mounting holesScrew side ramps to floor Mate side ramp to base trackDrill into concrete and screw down track AVTrac InstallationSecure connectivity box to the floor 12 AVTrac InstallationStep 4 Connectivity Box InstallationInstallation Step 5 Power ModuleConnect wires to AC receptacle AVTrac Installation14 AVTrac Installation Step 5 Power Module cont’dAttach AC power module Connect double isolated cable to junction boxRun cable to AAPs Install AAPsStep 6 AAPs InstallationFit cover track Step 7 Finishing UpEnsure cables lay flat Cut carpetAttach carpet tile to track raceway Refit carpetUse template to cut base board Reattach base board to wall AVTrac InstallationStep 7 Finishing up cont’d AVTrac installed18 AVTrac Installation InstallationAVTrac Reference Material SpecificationsReference Material GeneralReference Material cont’d20 AVTrac Reference Material AVTrac 480CTOP VIEW Connectivity boxAVTrac Reference Material SIDE VIEWReference Material Universal AC Compatibility Guide22 AVTrac Reference Material cont’dAccessory Optional AccessoriesTrack Accessories Active AAPs24 AVTrac Reference Material Reference Materialcont’d and Central America USA, Canada, South AmericaEurope, Africa, and the Middle East AsiaStep 3 - Install Connectivity Box Quick Installation ChecklistStep 2 - Install Track Step 4 - Install AC Power Module