Extron electronic FOX 2G Tx manual Projector mounting

Installation and Setup, cont’d

Projector mounting

Mount the FOX 2G Rx AV above a projector using an optional Extron Projector Mounting Kit. The following intructions apply to the PMK 350 (PN 70-563-0x). To use other projector mounting kits, consult the appropriate manual. Mount the receiver on the PMK 350 as follows:

1. Remove and retain the four screws holding the front and back panels of the PMK 350.

2. Remove the cover sheet.

3. Remove the rubber feet if these have been installed on the bottom of the FOX 2G Rx AV.

4. Secure the receiver to the mounting tray, using two of the 4-40 x 3/16" screws provided with the PMK 350 in diagonally opposite corners of the receiver.

5. Mount the power supply, using the provided plastic ties or Velcro® strips (see figure 2-4 below).

	Extron
Rear Plate	FOX 2G Rx AV

Extron	U-bolt
PMK 350
Multi-product Projector
Mounting Kit
	Power supply

Front Plate

Cover Sheet

Figure 2-4 — Projector mounting

6. Add any other unit(s), as required.

7. Place the PMK 350 around the projector ceiling mounting pole.

2-6 FOX 2G Tx/Rx AV • Installation and Setup