![](/images/new-backgrounds/1015995/1599533x1.webp)
Through-desk mounting
Mount the FOX 2G Tx/Rx AV through a desk or podium using the optional Extron MBD 129
1. Remove the rubber feet if these have been installed on the bottom of the unit.
2. Attach the brackets to the transmitter or receiver, using the four
Figure 2-3 — Through-desk mounting
3. Hold the unit in position, under the mounting surface.
Mark the location of the four screw holes and the mounting hole to be cut in the table.
4. Remove the table material. Test the fit by inserting the front of the device through the hole. If necessary, use a rasp or coarse file to enlarge the hole.
5. Drill four pilot holes, each 3/32" (2 mm) in diameter by 1/4" deep (6.3 mm) deep, as marked on the template.
6. Attach the brackets to the mounting surface, using the four #8 wood screws provided with the kit.
7. Slide the device in or out until the front panel is flush with the table surface. Tighten the screws installed in step 2.
8. If the screws are inaccessible to a screwdriver, mark the location of the unit relative to the bracket, remove the unit and bracket, tighten the screws and replace the unit as described in step 6.
FOX 2G Tx/Rx AV • Installation and Setup |