![](/images/new-backgrounds/1015995/1599587x1.webp)
Configuration, cont’d
3. Select the Com port to which your transmitter or receiver is connected and click Connect.
The Communication Setup window closes and the FOX Extender WCP window comes into focus (see figure
Figure 3-6 — FOX Extender WCP window
NOnly Link 1, connecting the Tx port of the transmitter to the Rx port of the receiver, is required for video, audio, and serial command transmission. Link 2 is not required but, if it is not enabled, the ability to configure the system is limited by a lack of communication from the receiver to the transmitter.
Status area
The Status area provides visual indications of the connection status:
Figure 3-7 — Status area
•Video present indicator — Shows green to indicate the presence of Composite,
•Audio present indicator — Shows green when the transmitter detects an audio signal at or above 35 dB below the nominal level. Stays on until the signal falls below this threshold continuously for 10 seconds.