Installation and Operation, cont’d
1. Loosely attach the mounting brackets to the transmitter or receiver using the four machine screws and washers supplied with the mounting kit.
2. Hold the transmitter or receiver against the inside of the surface through which it will be mounted. Mark the four screw holes and the table material to be removed on the inside of the surface to which you are mounting the device.
3. Remove the table material. Test the fit by inserting the front of the device through the hole. If necessary, use a rasp or coarse file to enlarge the hole.
4. Drill four pilot holes, each 3/32" in diameter by 1/4" deep, where you made marks.
5. Using the provided four wood screws, secure the brackets to the mounting surface.
6. Slide the transmitter or receiver up and down in the mounting brackets until the face of the transmitter or receiver is at the desired height. Tighten the screws that secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a. Mark the location of the brackets relative to the screws.
b. Remove the transmitter or receiver from inside the furniture.
c. Tighten the screws.
d. Replace the unit inside the surface (step 5).
Projector mounting
The receiver can be mounted on a projector bracket using either of the following optional Extron projector mounting kits:
•PMK 300
•PMK 350 low profile,
PMK 300 mounting
Mount the receiver to a PMK 300 bracket as follows:
1. If necessary, remove the feet from the bottom of the receiver.
2. Mount the receiver to one of the bracket’s three mounting plates using two of the supplied
Side Mounting
Plate
Bracket
Brace
Extron
DVI 201 or HDMI 201
Receiver
Power Supply
Extron
PMK 300
Front Mounting
Plate
Figure 2-5 — PMK 300 projector mounting a receiver
NOn the side mounting plates, the device is typically mounted on the outside of the bracket.
On the front mounting plate, the device is typically mounted on the inside of the bracket.
3. If the power supply is connected to the receiver, use the two included tie wraps to strap the power supply to one of the brackets.
HDMI 201 Tx/Rx • Installation and Operation | HDMI 201 Tx/Rx • Installation and Operation |