Installation and Operation, cont’d
Terminating shielded cable
NThe transmitter and receiver pair works with unshielded twisted pair (UTP) or shielded twisted pair (STP) cables; but, to ensure FCC Class A and CE compliance, STP cables are required.
The Tx/Rx includes four shielded
NExtron supplies the connectors and the shielded tape.
You must supply the CAT 5, 5e, 6, or 7 STP cable.
Terminate the STP cable as follows:
1. Peel back the cable shielding (figure
Peel back shield and fold back.
Figure 2-21 — Peeling back the cable shielding
2. Cut away and discard the clear cellophane inner wrapper from the end of the cable back to the
Crimped Connector
Figure 2-23 — Crimped RJ-45 connector
Power supply wiring
N• Only one power supply is required. A single power supply connected to either unit in the pair powers both units.
•A single power supply is included with systems packaged as a pair.
•A power supply is also included with each
Figure
CPower supply voltage polarity is critical. Incorrect voltage polarity can damage the power supply and the transmitter or receiver. Identify the power cord negative lead by the ridges on the side of the cord
(figure
To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter.
3. Peel the backing off the
Aluminum Tape | Wrap tape around folded foil shielding. | |
Slightly overlap. | ||
| ||
| Cut and save the excess tape | |
| for other connectors. |
Smooth Ridges
A | A |
Power Supply
Output Cord
SECTION
NOTE Decora units have a Tie Wrap shorter connector,
without the tie wrap.
3 5
Figure 2-22 — Wrapping the shielded tape
4. Cut the unused portion of the shielded tape and retain for shielding other
5. Feed each individual wire into the appropriate slot of the
|
|
|
| DC Power Cord |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
| (between power supply |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Ferrite Bead | and HDMI unit | Captive Screw | ||||||||
|
|
|
| power connector) | Connector |
Figure 2-24 — Power connector wiring
| HDMI 201 Tx/Rx • Installation and Operation |