Installation and Operation, cont’d
HDMI 201 Tx Rear Panel
POWER |
| HDMI 201 Tx |
12V | HDMI INPUT | |
0.4A MAX |
C | Input Audio — Plug an unbalanced stereo audio input into this |
| pair, left and right, of female RCA connectors (figure |
|
|
|
| PASS THRU |
|
| 1 | 2 | Tx Rx |
4 | 1 | 5 |
| 2 |
| HDMI 201 A D Tx Rear Panel |
|
|
Tip (Signal)
Sleeve (Gnd )
Right Channel (Red Jacket)
Left Channel (White Jacket)
Tip (+)
Sleeve ()
|
|
| HDMI 201 A D Tx |
|
|
|
| 2 |
|
|
|
| O |
|
|
|
|
| U |
|
|
|
|
| T |
|
|
|
|
5 | P |
| DO NOT | L |
|
| U |
| CONNECT | AUDIO OUTPUT |
|
| T |
| TO LAN | 6 | |
| S |
|
| ||
|
|
|
| ||
|
|
|
| R |
|
|
| 1 |
| POWER 12V MAX0.4A | 4 |
|
|
|
| ||
|
|
|
|
|
Figure 2-13 — HDMI 201 Tx rear panel connectors
NThe
| Figure |
D | DC power input connector — Plug the included external |
| 12 VDC power supply into either this |
| power input connector on the receiver (item Gon page |
| See "Power supply wiring," on page |
E | Transmitter output connector — Connect one end of two |
| separate TP cables to these |
| transmitter. |
| C Do not connect these devices to a computer data or |
| telecommunications network. |
| N Extron recommends 28AWG to 24AWG TP cable for the |
| |
| Connect the free ends of the same TP cables from the transmitter |
| to the receiver’s Input |
| page |
| N Connect transmitter output 1 to receiver input 1. |
| Connect transmitter output 2 to receiver input 2. |
| N If necessary, test for proper cable connection (output 1 to |
| input 1, output 2 to input 2) as follows: |
| 1. Plug both TP cables into the powered unit. |
| 2. Momentarily connect either of the cables on the |
| opposite end into the unpowered unit‘s “2” connector. |
| If the unpowered unit’s Power LED is lit, the |
| connection is correct. |
| If the unpowered unit’s Power LED is not lit, |
| unplug the connector on the unpowered end and |
| connect the other cable to the “2” connector. |
| See "TP cable termination," on page |
| the |
| HDMI 201 Tx/Rx • Installation and Operation |