Extron electronic HDMI 201 Rx Installation and Operation, cont’d, 3- Under-deskmounting

Installation and Operation, cont’d

1U Universal Rack Shelf	1/2 Rack Width
	Front False
	Faceplate 1/4 Rack Width
	Front False
	Faceplate

Both front false faceplates use 2 screws.

Use 2 mounting holes on opposite corners.

(2) 4-40 x 3/16" Screws

Figure 2-3 — Under-desk mounting

Figure 2-2 — Mounting the transmitter or receiver unit on a standard rack shelf

Under-furniture mounting

The unit can be mounted under a horizontal surface using an optional MBU 125 under-desk mounting kit (part #70-077-01). Mount the unit under a desk or table as follows:

1. Secure the under-desk mounting brackets to the transmitter or receiver with the four machine screws provided in the mounting kit (figure 2-3).

2. Hold the transmitter or receiver with attached brackets against the underside of the desk or other furniture. Mark the location of holes for screws on the desk.

3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or desk at the marked screw locations from the underside or inside (the concealed side) of the furniture, where the transmitter or receiver will be located.

4. Insert the four wood screws into the pilot holes. Fasten each screw into the installation surface until just less than 1/4" of the screw head protrudes.

5. Align the installed screws with the slots in the mounting brackets, and place the transmitter or receiver against the surface, with the screws through the bracket slots.

6. Slide the transmitter or receiver slightly forward or back, then tighten all four screws to fasten it in place.

Through-furniture mounting

The transmitter or receiver can be mounted through a desk or other furniture using an optional Extron MBD 129 through-desk mounting kit, part #70-077-02. Mount the transmitter or receiver through a desk or table as follows (figure 2-4):

Figure 2-4 — Through-desk mounting

2-4 HDMI 201 Tx/Rx • Installation and Operation HDMI 201 Tx/Rx • Installation and Operation 2-5