Installation and Operation, cont’d
2.50” [63.5mm]
Wall Stud | Wall Stud | |
Signal | Signal | |
Output | ||
Output | ||
Cable | ||
Cable | ||
| ||
Cable | Cable | |
Clamp | Clamp |
TP Cable (no boot)
Captive
Screw
Connectors
TP Cable (no boot)
1.51” [38.48mm]
Screws | Screws | |
or Nails | ||
or Nails | ||
|
Figure 2-10 — Installing the wall box
N If attaching the wall box to wood, use four #8 or #10 |
screws or |
of screw thread must penetrate the wood. |
Junction Box
1.85” [47mm]
Figure 2-9 — Decora unit depth profile
To install a new wall box, perform steps 1 through 9 below. If a suitable wall box is already installed, perform steps 6 through 9 below. UL listed wall boxes are recommended.
1. If a wall box is not available to use for a template, use the dimensions on page
2. Place the wall box (or your template) against the installation surface, and mark the opening guidelines.
3. Cut out the material from the marked area.
4. Insert the wall box into the opening. The box or the wall plate’s rear connectors should fit easily into the opening. Enlarge or smooth the edges of the opening if needed.
5. Secure the wall box with nails or screws, leaving the front edge flush with the outer wall or furniture surface. See figure
If attaching the wall box to metal studs or furniture, |
use four #8 or #10 |
machine bolts with matching nuts. |
6. Feed the TP cables and, if applicable, the audio and power cables through the opening and through the wall box
NIn order to fit in the junction box, the TP cables and
NOne power supply can power both the transmitter and the receiver, so only one unit needs a power supply.
7. Trim back and/or insulate exposed cable shields with heat shrink to reduce the chance of short circuits.
To prevent short circuits, the outer foil shield can be cut back to the point where the cable exits the cable clamp.
8. Connect the cables to the rear of the unit. See "Connections", later in this manual, for connector wiring details.
9. Connect front panel devices (see "Connections", later in this manual, for connector details), restore the power supply, and test the transmitter/receiver system. Make any cabling adjustments before final installation, as the cables will be inaccessible afterwards.
| HDMI 201 Tx/Rx • Installation and Operation |