Extron electronic HDMI 201 Rx Receiver connections, 2-18HDMI 201 Tx/Rx Installation and Operation

Installation and Operation, cont’d

F	Audio Output connector (HDMI 201 A D Tx [Decora] only) —	Receiver connections
		The rack-mountable receiver is in quarter rack width enclosure.
	Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole
	direct insertion connector.	The wall-mountable receiver is in an enclosure that can be
	Connect the free end of the same cable from the transmitter to	mounted in UL standard wall boxes with Decora-style face
		plates.
	any compatibly wired unit, such as a switcher, an amplifier, or
		Figure 2-16 shows the rear panel of both HDMI 201 Rx models.
	an HDMI 201 A D Rx (Decora) receiver (item Kon page 2-21).
		Figure 2-17 shows the front panel of the HDMI 201 A D Rx
	Figure 2-15 shows how to wire the captive screw audio	(Decora) receiver.
	connector. Insert the wires into the appropriate openings in the	HDMI 201 Rx Rear Panel
	direct insertion connector. Tighten the screws on the side to
			HDMI 201 Rx
	fasten the wires.	POWER
		12V

							0.4A MAX		HDMI OUTPUT	RS-232
		Unbalanced Output			Balanced Output					PASS THRU
	R	NO GROUND HERE.		R	Ring		1	2		Tx Rx
AUDIO	OUTPUT	Tip	AUDIO	OUTPUT	Tip
		NO GROUND HERE.			Ring
	L			L
		Sleeve (s)			Sleeve (s)
		Tip			Tip	Do not tin the wires!	7	8	9	10

Figure 2-15 — Captive screw connector wiring for	HDMI 201 A D Rx Rear Panel
transmitter audio output

CConnect the sleeve to ground (Gnd). Connecting the sleeve to a negative (–) terminal will damage the audio output circuits.

8

		HDMI 201 A D Rx
	2
I
N
P		DO NOT
U			L
		CONNECT
T
		TO LAN	AUDIO INPUT
S
			R
	1		POWER 12V 0.4A MAX

11

7

Figure 2-16 — HDMI 201 Rx rear panel connectors

2-18 HDMI 201 Tx/Rx • Installation and Operation HDMI 201 Tx/Rx • Installation and Operation 2-19