Extron electronic user manual Packaging for Shipment, Figure B-1 HSA 822 return kit

Packaging for Shipment

The HSA 822’s ultra-fine machined surfaces and moving parts make them vulnerable to damage caused by mishandling during shipment if they are improperly packaged. If, for any reason, you need to return an HSA to Extron, first contact Extron to obtain a return kit. The return kit, which reduces the chances of damage during shipment, includes a sturdy shipping carton and foam cut to fit the HSA (figure B-1).

Figure B-1 — HSA 822 return kit

Package an HSA for shipment as follows:

1.	Contact the Extron S3 Sales & Technical Support Hotline to
	obtain a return kit. Extron will send the repair kit to the
	location you specify.
		The flanged edges of the top of the surface enclosure
		are sharp when the HSA is removed from the table.
		Exercise caution when handling to prevent personal
		injury.
		The flanged edges of the top of the surface enclosure
	CAUTION
		are bevelled to an ultra-fine thickness of less than

0.04(4/100)" (approximately 1 mm). These edges are soft and can be easily nicked or bent. Exercise caution when handling and mounting the enclosure. Mishandling can damage the appearance of the enclosure.

2.	Disconnect all cables, remove any AAPs, and remove the
	HSA 822 from the table or desk. See “Removing and
	Replacing the Enclosure”, steps 1 through 8, in chapter 3,
	“Maintenance and Modifications”. Place the enclosure
	upside-down on a horizontal surface. To protect the finish,
	place the enclosure on a soft cloth or rubber mat.
3.	Bolt the clamshell to the enclosure with two bolts and flat
	washers included in the return kit (figure B-2).

Figure B-2 — Attaching the clamshell

B-2 HSA 822 Hideaway® Enclosure • Packaging for Shipment HSA 822 Hideaway® Enclosure • Packaging for Shipment B-3