Extron electronic IPL T CR48 Reset Mode Summary, Mode Activation Result Purpose and Notes, Use

IPL T CR48 Reset Mode Summary

	Mode	Activation	Result	Purpose and Notes
	1	Hold down the recessed Reset button	The IPL T CR48 reverts to the	Use mode 1 to revert to the factory
		while applying power to the IPL T CR48.	factory default firmware.	default version if incompatibility issues
		NOTE: After a mode 1 reset is	Event scripting does not start if the	arise with user-loaded firmware.
			unit is powered on in this mode. All	NOTE: User-defined Web pages may
		performed, update the firmware
			user files and settings (such as drivers,
		of the unit to the latest version.		not work correctly if using an
			adjustments, and IP settings) are
		Do not operate the IPL T CR48		earlier firmware version.
			maintained.
		firmware version that results
			NOTE: If you do not want to update
Firmware		from the mode 1 reset. This
		mode temporarily resets the unit	firmware, or you performed a
		to factory default until power is	mode 1 reset by mistake, cycle
		recycled. If you want to use the	power to the unit to return to the
		factory default firmware, you	firmware version that was running
Factory		must upload that version again.	prior to the mode 1 reset. Use the
			0Q SIS™ command to confirm that
			the factory default firmware is no
			longer running (look for asterisks
Use			following the version number).
	3	Hold down the Reset button for about	Mode 3 turns events on or off.	Mode 3 is useful for troubleshooting.
		3 seconds until the Power LED blinks	If the events are currently stopped
		once, then release and press Reset	following the momentary press, the
		momentarily (<1 second) within	power LED flashes twice, indicating
Run/Stop	Events	1 second*.	the starting of events. If the events
			events.
			are currently running following the
			momentary press, the Power LED flashes
			three times indicating the stopping of
	4	Hold down the Reset button for about	Mode 4:	Mode 4 enables you to set IP address
		6 seconds until the Power LED blinks	zzEnables ARP capability	information using ARP and the MAC
		twice (once at 3 seconds, again at		address.
			zzSets the IP address back to factory
		6 seconds). Then, release and press
			default (192.168.254.254)
		Reset momentarily (for <1 second)
			zzSets the subnet back to factory
		within 1 second*.
			default
			zzSets the default gateway address to
ResetAll	SettingsIP		the factory default
			zzTurns events off
			zzSets port mapping back to factory
			default
			zzTurns DHCP off
	5	Hold down the Reset button for about	Mode 5 performs a complete	Mode 5 is useful if you want to start
		9 seconds until the Power LED blinks	reset to factory defaults	over with configuration and uploading,
		three times (once at 3 seconds, again at	(except the firmware).	and also to replace events.
		6 seconds, again at 9 seconds). Then,	zzDoes everything mode 4 does
		release and press Reset momentarily (for
			zzClears driver-port associations and
Factory		<1 second) within 1 second*.	port configurations
			zzRemoves button/touchpanel
			configurations
Resetto	Defaults		zzResets all IP options
			IPL T CR48
			zzRemoves scheduling settings
			zzRemoves/clears all files from the

*For modes 3, 4, and 5, nothing happens if the momentary press does not occur within 1 second.

IPL T CR48 • Installation and Operation 9