Extron electronic IPL T CR48 manual Symbol definitions, ASCII-to-HEX Conversion Table

Symbol definitions are shown below. An ASCII to HEX conversion table is also provided in

figure 21.

ASCII to Hex Conversion Table

Space

•

Figure 21. ASCII-to-HEX Conversion Table

Symbol definitions

]

}

•

X!

X#

X%

X1!

X1@

X1#

X1$

X1%

X1*

X1(

X2@

=CR/LF (carriage return/line feed)

=Carriage return (no line feed)

=Space (hard) character

=Specific port number (01-99)

The port number will be represented as two ASCII characters (2 bytes)

=Greenwich Mean Time (GMT) offset value (-12.0 to +14.0)

=On/off status: 0 = off/disable; 1 = on/enable

=Unit version number

=Name is a text string up to 24 characters drawn from the alphabet (A-Z), digits (0-9), and

minus sign/hyphen (-). No blank or space characters are permitted as part of a name. No distinction is made between upper and lower case. The first character must be an alpha character. The last character must not be a minus sign/hyphen.

=Set local date and time format (MM/DD/YY-HH:MM:SS) for example, 06/18/10-10:54:00; Read local date and time format (day of week, date month year HH:MM:SS) for example, Fri, 18 Jun 2010 18:19:33

=IP address (xxx.xxx.xxx.xxx); leading zeros in each of four fields are optional in setting values and are suppressed in returned values

=Mail Domain name (for example, extron.com, icia.org)

=Hardware (MAC) address (xx-x-xx-xx-xx-xx)

=Subnet mask (xxx.xxx.xxx.xxx); leading zeros in each of four fields are optional in setting values and are suppressed in returned values

=Verbose/response mode status: 0 = clear, default for Telnet connections; 1 = verbose mode is on;

2 = send tagged responses for queries; 3 = verbose mode is on and tagged responses are sent for queries

NOTE: If tagged responses are enabled, all read commands return the constant string + the

data or value, the same as in responses for setting a value. For example, for E CN }, the response is Ipn• X1@ ] rather than just the data (X1@ ]).

X2#

X3#

=Priority status for receive timeout: 0 = priority set to Send Data String command parameters;

1= priority set to configure received timeout command parameters.

=Password: maximum length of 12 characters and no special characters.

NOTE: User password cannot be assigned if no administrator password exists and returns E14. If the administrator password is cleared, then the user password is also removed.

X3$

X3%

X3^

X3&

=Daylight saving time: 0 = off/ignore; 1 = on (use in northern hemisphere) (USA) ; 2 = on (Europe); 3 = on (Brazil)

=Event number: range = 0 - 99 (max.)

=Event buffer: 0 = receive; 1 = user (absolute); 2 = user (relative); 3 = NVRAM

=Event buffer offset: range = 0 - MaxBufferSize

IPL T CR48 • Communication and Control 24