Extron electronic MTP 15HD RSA manual Board Connections, LEDs, and Rear Panel Features

3.Carefully slide the board into the slot, aligning the two tabs on the lower front end of the board with the matching ports in the enclosure. Push the board firmly into place. Tighten the screws to secure the board in place.

NOTE: Use a tool to fully tighten the screws after initial installation and

subsequent removal and replacement of the boards..

4.Repeat steps 2 and 3 for all boards needing installation.

Board Connections, LEDs, and Rear Panel Features

		PowerCage
		MTP T
4		15HD RSA
3		OUTPUT
5	PRE-PEAK ON	OFF
1		INPUT
2	INPUT	R
	AUDIO	L
6	RS-232	Tx Rx

PowerCage

MTP R

15HD RSA SEQ

INPUT
OUTPUT
RS-232	Tx Rx
AUDIO
ADJUST
SELECT
R G/L	B/P

4

3

1

2

9

8

7

PowerCage	PowerCage
MTP T 15HD RSA	MTP R 15HD RSA SEQ

Figure 2. PowerCage MTP 15HD RSA Board Connectors

a15-pin HD VGA connectors —

MTP T 15HD RSA board — Connect RGB, HD-YUV, YUV, S-video, or composite inputs to this connector.

MTP R 15HD RSA SEQ board — Connect suitable display devices to this connector for RGBHV, RGBS, RGsB, RsGsBs, HD-YUV, YUV, S-video, or composite output.

NOTE: DIP switch settings on the receiver allows the user to switch chroma from the red channel to the blue channel.

bAudio connector (5-pole captive screw) —

MTP T 15HD RSA board — Connect an audio input source to the 5-pole captive screw connector. Wire the captive screw connector as shown below. Use the supplied tie-wrap to secure the audio cable to the connector.

Tip

Sleeve

	Tip
Do not tin the wires!	Sleeve

Unbalanced Stereo Input

Tip	L
Ring
Sleeve (s)
Tip	R
Ring

Balanced Stereo Input

Figure 3. Captive Screw Connector Wiring for Stereo Audio Input

MTP R 15HD RSA SEQ board — On this board, this is an audio and RS-232 output connector. Wire and insert a 5-pole captive screw connector for mono audio and/or RS-232 serial output. Wire the connector as shown in figure 4.

PowerCage MTP T 15HD RSA and PowerCage MTP R 15HD RSA SEQ • Installation and Operation 5