Extron electronic MTP U R RS SEQ, MTP U R A Installation, cont’d, MTP U R Series Installation

Installation, cont’d

APower connector — Plug the included external 12 VDC power supply into this 2-pole captive screw connector. See “Power supply wiring” to wire the connector.

BInput 1 connector — Connect one end of the cable from the transmitter.

See “TP cable termination” to wire the RJ-45 connectors.

C Do not connect these devices to a computer data or telecommunications network.

CComponent video output connectors (MTP U R RSA SEQ model only) — Connect a suitable device to these three female

BNC connectors for component (Y, R-Y, and B-Y) video output.

NFor MTP U R RS SEQ, MTP U R RS, and

MPT U R A models, component video is output on the 15-HD VGA connector.

Video output can be bi- or tri-level sync.

The MTP transmitter jumper needs to be set to tri-level for 720p and 1080i HDTV component video applications For 1080p HDTV applications set the jumper to bi-level.

DHigh resolution video output connector — Connect a projector or other high resolution video device to this 15-pin HD connector for RGB output.

The pin-out for the 15-pin HD connector is as below

NInput only sync signals, no video signals, on the sync pins (13 and 14).

For component video, use the R (R-Y) and R return pins (pins 1 and 6), G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins (pins 3 and 8).

The MTP U R receiver’s horizontal and vertical sync output is negative by default. To change the polarity, reset the jumper position on JMP 2 and JMP 3.

EComposite video output connector — Connect an appropriate display device to this female BNC connector for composite video output.

FS-video output connector — Connect an appropriate display device to this 4-pin mini DIN connector for S-video output.

NOnly one of the above video connectors (Cthrough F) can be active at a time. The MTP U R device auto detects the signal format and outputs it on the appropriate connector. The other connectors are muted.

14MTP U R Series • Installation