G
RS-232 communication. Wire the connector as shown below.
Connected | MTP | |
Device Pins | ||
Pins | ||
Receive | ||
Tx | ||
Transmit | Rx | |
Ground | Gnd | |
| Spare | |
| Spare |
Figure 14 — Pin assignments for RS-232 wiring
NTo set the connector for unidirectional communication, see “Setting JMP1 for
Set up the receiver for unidirectional communication when it is to be used with an MTP DA to avoid any
When with an MTPX Matrix Switcher, set up the receiver for unidirectional for transmitter to receiver communication; otherwise it should be set to bidirectional when using the
HAudio connector (MTP U R RSA SEQ and MTP U R A models only) — Connect a suitable audio device to this
| Mono output 1 | MONO L | Mono output 1+ | MONO L |
| NO GROUND. | Mono output 1- | ||
| Sleeve(s) | AUDIO R | Sleeve(s) | AUDIO R |
Do not tin the wires! | Mono output 2 | Mono output 2+ | ||
NO GROUND. |
| Mono output 2- |
| |
| Unbalanced Output |
| Balanced Output |
|
Figure 15 — Audio connector wiring
MTP U R Series • Installation | 15 |