Extron electronic MTP U R A, MTP U R RS SEQ, MTP U R RSA SEQ manual Specifications, cont’d

Specifications, cont’d

THD + Noise	0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal
	level
S/N	>70 dB at maximum output (unweighted)

Audio input — MTP U R RSA SEQ, MTP U R A — See MTP Series transmitters’ audio output specifications

Number/signal type	1 set of proprietary analog signals
Connectors	1 female RJ-45

N0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV 2 dBu

Audio output — MTP U R RSA SEQ, MTP U R A

Number/signal type	2 mono, balanced/unbalanced
Connectors	(1) 3.5 mm captive screw connector, 5 pole
Impedance	50 ohms unbalanced, 100 ohms balanced
Gain error	±1 dB channel to channel

Control/remote — external device (pass-through, unidirectional or bidirectional) (MTP U R RSA SEQ, MTP U R RS SEQ, or MTP U R RS)

Serial control port input/output. RS-232 via (1) 3.5 mm,

3 pole captive screw connector

NThe serial communications link of an MTP U R RSA SEQ, MTP U R RS SEQ, or MTP U R RS is bi-directional (default), unless the receiver’s jumper JMP 1 is set to uni-directional.

Set up the receiver for uni-directional communication when it is to be used with an MTP DA to avoid any RS-232/Audio detection issues.

When with an MTPX Matrix Switcher, set up the receiver for uni-directional for transmitter to receiver communication; otherwise it should be set to bi-directional when using the RS-232 output insert connections on the matrix.

Baud rates	Up to 38400 bps at up to 600' (152 m)
	(Higher data rates and distances are
	possible. Performance will vary based on
	baud rate and cable length.)
Protocol	Data bits = 5 - 8
	Stop bits = 1 or 2
	Parity = odd, even, none
	Flow control = XON, XOFF, none

24MTP U R Series • Specifications