Extron electronic P/2 DA6XI, P/2 DA4XI manual Under-deskmounting, P/2 DA4xi/6xi User’s Guide

1.If rubber feet were installed on the bottom of the case, remove them.

2.Mount the unit on the rack shelf, as shown below, using two 4-40 x 3/16 screws in opposite (diagonal) corners to secure the case to the shelf.

Under-desk mounting

Under-desk mount the unit using the optional mounting kit (part #70-077-01) as follows:

1.If rubber feet were installed on the unit, remove them.

2.Attach the mounting brackets to the unit with the provided machine screws, as shown below.

3.Hold the unit with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.

4.Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.

5.Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" of the screw head protrudes.

6.Align the mounting screws with the slots in the brackets and place the unit against the surface, with the screws through the bracket slots.

7.Slide the unit slightly forward or back, then tighten all four screws to secure the unit in place.

P/2 DA4xi/6xi • User’s Guide 3