CVEQ 100 and SVEQ 100 Series • Quick Start Guide
QS-1
Quick Start Guide — CVEQ/SVEQ 100 Series
C Installation and service must be performed by authorized
personnel only. These line drivers must be used with UL
approved, grounded electrical boxes.
To install and set up the line driver, follow these steps and see the
appropriate sections of this manual for details.
Step 1
Turn the input and output devices off and unplug their power cords.
Verify that the line driver is disconnected from the power source
before proceeding.
Step 2
Attach output cables to the rear panel of the line driver and to the
output devices. See "Rear Panel Features and Operation" in chapter 3
for details.
Step 3
Attach input cables from the input devices to the line driver’s front
panel input connectors. See "Front Panel Features and Operation" in
chapter 3.
Step 4
Connect power cords (see page 3-11) and turn on the output devices
(project or/monitor, speakers) and input devices.
Step 5
The picture should appear and sound should be audible. If not,
ensure that all devices are plugged in and receiving power. Check
the cabling, make adjustments as needed. For further details, see
"Testing and troubleshooting" in chapter 2.
Step 6
While watching the display, adjust the video gain and
equalization by using the rotary gain and equalization (EQ) control
potentiometers. An oscilloscope can be used to achieve a more
precise adjustment. See “Gain adjustment control" and "Equalization
(EQ) adjustment control” in chapter 3 for details.
Make all adjustments using an Extron Tweeker or small screwdriver.
If using very short output cables, set all potentiometers to the default
setting (the arrow on the control pointing to the dot beside it).
CVEQ 100 Series SVEQ 100 Series