RS-232/Remote Control, cont’d
The Universal Switcher Control Program, part
•Input selection (including audio breakaway for models with video and audio)
•Audio gain and attenuation adjustments (audio models)
•Front panel switch mode selection
Updates to this program can be downloaded from the Extron Web site (http://www.extron.com).
Installing the software
The program is contained on a single 3.5” diskette and can be run from the floppy drive, or it can be installed and run from the hard drive.
To install the software on the hard drive, run setup.exe from the floppy disk and follow the screen instructions.
By default, the Windows installation creates a C:\UNIVSW folder and places two icons (Universal Switcher Control Program and Universal Switcher Help) into a group named “Extron Electronics”.
Using the software
1. | To run the software, double click on the Universal | |
| Switcher Control Program icon in the Extron | |
| Electronics program group. | |
| 2. | Click on the comm port that is connected to |
|
| the switcher’s |
| 3. | The Extron Universal Switcher Control |
|
| Program window (Figure |
|
| selected input, the audio gain for the selected |
|
| input, and the panel mode. |
Figure 4-2 — Universal Switcher program window
Using the help system
For information about program features, you can access the help program in any of the following ways:
•From the Extron Electronics program group,
•From within the
•From within the
Contact Closure Remote Control
The Remote connector also provides a way to select an input to the switcher using a remote contact closure device. Contact closure control uses pins on the Remote connector that are not used by the
To select a different input number using a contact closure device, momentarily short the pin for the desired input number to logic ground (pin 5). To force one of the inputs to be always selected, leave the short to logic ground in place. The short overrides front panel input selections.
Audio/Video Switchers • | Audio/Video Switchers • |