Extron electronic YCS SW2 A user manual Projector mounting using the PMK

Installation and Operation, cont’d

4.	Repeat steps 2 and 3 on the other side of the YCS.
5.	Hold the unit with the attached brackets against the
	underside of the table or other furniture. On the mounting
	surface, mark the location of the bracket’s screw holes.
6.	Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
	deep in the mounting surface at the marked screw
	locations.
7.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until slightly less
	than 1/4" of the screw head protrudes.
8.	Align the mounting screws with the slots in the brackets
	and place the unit against the surface, with the screws
	through the bracket slots.
9.	Slide the unit slightly forward or back, then tighten all four
	screws to secure it in place.

Projector mounting using the PMK 450

The Extron PMK 450 Multi-Product Projector Mounting Kit (part #70-618-02 or #70-618-03) can accommodate multiple Extron products of various sizes and their power supplies.

Top Plate (1)

Pipe Collar (1) and

Set Screws (4)

AC Power Cord

Access Slot

Front Plate (1)

Security Screw (2) Rear Plate (1)

Extron

YCS SW2 A

Transcoding

Switcher

Bottom Plate (1)

Filler Plate (1)

Figure 2-7 — Components of the Extron PMK 450 kit

2-8 YCS SW2 A • Installation and Operation

Two tools are included with the PMK 450 kit:

•A set-screw hex wrench

•A security screw hex wrench

To projector-mount the YCS SW2 A using the PMK 450,

1.Unscrew the front and rear plates and the security screws from the sides of the PMK 450.

2.	Slide the top and bottom plates apart.
3.	Loosen the four pipe collar set screws to allow the top
	plate to move freely along the pole.
4.	Ensure that the mounting pipe is installed with the cable
	access hole facing the rear, away from the projector screen.
5.	Slide the top plate up the pipe until the pipe collar is
	positioned just above the cable access hole. Ensure the rear
	of the top plate is facing to the rear, in the same direction as
	the cable access hole in the pipe.

Pipe Collar and

Set Screws

FRONT

REAR

Figure 2-8 — Positioning the top plate on the pipe

6.	Level the top plate and secure it by fully tightening the set
	screws. At least three screws must come in contact with
	the pipe.
7.	Route the cables for the devices to be mounted so that the
	cables exit the pipe through the cable access hole.

YCS SW2 A • Installation and Operation 2-9