Installation and Operation, cont’d
H | |
| to this female |
I | Input 2 connector — Connect an |
| |
J | Power connector — Plug the external 12 VDC power supply |
| into this |
Wiring the Power Connector
If using a different external power supply from the one provided with the YCS, you may need to wire the connector for it.
To wire the power connector,
1. | Cut the DC output cord to the length needed. |
2. | Strip the jacket to expose 3/16 inch (5 mm) of the |
| conductors. |
CExposing more than 3/16” (5 mm) of the copper wires could allow the stripped wires to touch each other, causing a short circuit. This could result in the external DC power supply overheating and/or burning.
Stripping the wires to expose less than the recommended amount may cause them to slide out of the connector too easily, even if they are tightly pinched by the captive screws.
3. | Slide the leads into the supplied |
| and secure them, using an Extron Tweeker or other small |
| screwdriver. |
4. | To verify the power cord’s polarity before connecting |
| it, plug in the power supply with no load and check the |
| output with a voltmeter. |
The figure on the next page shows how to wire the connector.
Smooth | Ridges |
| |
A | A |
SECTION
Power Supply |
|
Output Cord | Tie Wrap |
3/16” (5 mm) Max.
Orange Captive Screw
Connector
Figure 2-11 — Power connector wiring
CDo not tin the stripped power supply leads before attaching the captive screw plug to them. Tinned wires are not as secure in the captive screw connectors and can be easily pulled out. They may also break after being bent several times.
WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before wiring.
Audio Connectors
The YCS SW2 A has six RCA audio connectors: two left channel inputs (white), two right channel inputs (red), one left output (white) and one right output (red). Figure
Tip (+)
Sleeve (
) 
RCA Connector
Figure 2-12 — RCA audio connector pinout
YCS SW2 A • Installation and Operation |
