Falcon U109988 - 02 To Replace an Oven Fan, To Remove the Left-hand Oven Bottom and Top Elements

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

21.To Remove the Fan Oven Element

Disconnect from electricity supply.

Remove the oven inner back (see 20). Remove the two screws from the top of the element and the one from the bottom of the element inside the oven (Fig.7-12).

Lift the element out carefully, disconnecting the terminals connected to the element (noting their positions).

If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear.

Remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear.

22.To Replace an Oven Fan

Disconnect from electricity supply.

Pull the cooker forward to gain access to the rear. Remove the screws securing the electric cover to the back sheet and remove the cover.

Disconnect the three terminals connected to the fan noting their position. Remove the oven inner back (see 20). Hold the fan blade and remove the centre nut (left-hand thread) two brass washers, fan blade and circlip. Unscrew the fan retaining nuts and washers (three off each) and lift the fan away from the rear of the cooker. Fit the new fan and reassemble in reverse order. Check the operation of the oven.

23.To Remove the Left-hand Oven Bottom and Top Elements

Disconnect from the electricity supply. Bottom Element

Fig.7-12

��������������������

ArtNo.321-0005 Fan oven element

Fig.7-13

ArtNo.321-0007 - MF oven element 1

�

Fig.7-14

ArtNo.321-0008 - MF oven element 2

Pull the cooker forward to access the cover boxes at the rear of the unit. Remove the fixings that secure the cover and lift it clear.

Remove the two screws ‘A’ and allow the plate to drop down (Fig.7-13). Remove the two screws ‘B’ holding the element to the bottom sheet (Fig.7-14). Undo the terminal connections, noting their positions. Withdraw the element.

Replace the element and re-assemble parts in reverse order.

Top Element

Open the left-hand oven door and undo the fixings that secure the heat shield. Remove the top element bracket fixings and withdraw the element.

Replace the element and re-assemble parts in reverse order. Check that the oven operates satisfactorily.

24.To Change Oven Light Bulb

Disconnect from electricity supply.

Make sure the oven is cool. Open the oven door and remove the oven shelves. Remove the grill pan and support from the grill chamber.

Unscrew the bulb cover by turning anticlockwise. It may be very stiff (Fig.7-15). Taking care to protect your fingers in case the bulb should shatter, unscrew the old bulb.

Fit an Edison screw fitting 15W 240V lamp, FOR OVENS. It must be a special bulb, heat resistant to 300°C (Fig.7-16).

Screw in the new bulb, and then screw back the bulb cover. Turn on the electricity supply and check that the bulb now lights.

�

Fig.7-15 Fig.7-16

ArtNo.324-0007 Unscrewing the bulb cover ArtNo.324-0005 Oven light bulb

25