FARGO electronic 7KDAB manual SY Send Y-Modem, RY Receive Y-Modem, LO Logout, Reboot Reboot DAB

SY – Send Y-Modem

Allows a file to be sent from the DAB to the users computer via the serial port.

Most any popular terminal program written in the past 10-15 years will support Y-Modem file transfers. Since each program is different, please consult that software’s documentation for use of the file transfer capabilities of your terminal emulation program.

The filename you wish to download into your computer should be specified on the command line, and needs to exist in the present working directory.

Example:

7kDAB-\>sy config.ini

Start your YMODEM Download now.

At which point you would start your file transfer software.

RY – Receive Y-Modem

Allows one or more files to be sent to the DAB from the users computer via the serial port.

Example:

7kDAB-WAV\4300>ryCCCCC

The “C”’s shown in the example above are sent periodically by the DAB to signal to the host computer that the DAB wishes to start receiving files using the CRC checksum method. One startup character is sent every 3 seconds, and up to 20 attempts are made before timing out.

LO – Logout

This command simply terminates a command line session, and will cause a modem to disconnect.

REBOOT – Reboot DAB

This command unceremoniously causes the DAB to reboot. It may be used to take advantage of new settings in the CONFIG.INI file.

SMHOST – Force Smart Host Present Flag

This command is needed after a Reboot command is issued in order to simulate a special handshake sequence that occurs when the 7K controller containing Version 2.04 software first powers up. Unless this handshake sequence is seen by the DAB, some of the more advanced features, such as being able to send commands to the 7K, will be locked out.

Do not issue this command unless your 7K controller has Version 2.04 software.

7KDAB, Version 2.0, 19-Aug-2007 © Vyex LLC, 2003-2007 25