Start / Pause
This button has a number of functions. It serves to:
·Start the DishDrawer once the desired wash program has been selected.
·Interrupt the wash program while in operation.
To pause the DishDrawer, press the Start / Pause button and wait until you have heard two additional beeps before you open the drawer, allowing the lid seal to deflate. While in pause mode, the light above the Start / Pause button will flash.
·Restart the DishDrawer after being paused.
You may notice a delay after the Start / Pause button has been pressed. During this time the lid seal will be inflating.
·One Button Start.
This starts the DishDrawer and will run the last wash program used.
NOTE:
Under no circumstances do we recommend that you open the DishDrawer while in operation unless you have pressed the Start / Pause button. If the drawer is opened during the wash program, there is a possibility of getting wet, burnt, or damaging the DishDrawer. There are safety mechanisms in place to stop the DishDrawer if it is opened.
If a red light appears above the Start / Pause button, check the secondary control panel and note which lights are lit up. If the red lights above the rinse and fast are lit this indicates that the door was opened during the wash program. To remove this fault, ensure the drawer is closed and press Power. The DishDrawer will now be ready to start from the beginning of the wash program. You may have to add more detergent in the dispenser and then press Start / Pause button to start the DishDrawer. The DishDrawer will not restart where it was interrupted after a fault.
Lock
The Lock function disables all the other functions on the DishDrawer. This function is useful when cleaning the control panel and can also prevent children from turning the DishDrawer on or off accidentally. This button can be used when the DishDrawer is in operation and will remain active until the Lock is deactivated.
To activate this function, press and hold the Lock button until the red light above it appears continuously and is no longer blinking. All the other buttons are now inactive.
To deactivate this function, press and hold Lock button until the red light above this button has disappeared.
Figure 2 - Display showing the lock mode
9
