Fisher & Paykel DS602 manual Fault Code Displays

FAULT CODE DISPLAYS

When a fault occurs, the light above the Start / Pause button is red and secondary panel light(s) inside the DishDrawer will indicate the type of fault which has occurred. The DishDrawer will continuously beep every second until the Power button has been pressed.

The fault codes are as follows and we recommend that you check the chart below to correct the fault where possible. If the fault code cannot be removed by pressing the Power button, turn the Power off at the mains supply, wait 10 seconds and turn the DishDrawer on again. When the red light above the Start / Pause button has disappeared, run the DishDrawer on a wash program to ensure the fault has been completely eliminated. If the fault code still appears, call your Fisher & Paykel Authorized Service Agent.

You are reminded that if you call a Fisher & Paykel Authorized Service Agent because of a user fault, it is not covered by the Warranty. Should you encounter any problems then we recommend that you telephone our Fisher & Paykel Customer Care Center on 1 888 9 367 872.

			INDICATIVE LIGHTS
FAULT							WHAT TO DO
	Rinse		Heavy	Normal	Fast	Delicate
FAULT CODE U2
Drawer		λ			λ		Press the Power button
opened							to clear the fault.
during wash							Always press the
							Start/Pause button
							before opening the
							drawer if wash is in
							progress
FAULT CODE U3
Incorrect		λ			λ	λ	Change the water
water							pressure setting to "HP".
pressure							Refer to Section on
setting							Option Adjustment
							Mode.
Drain pump							Clear the motor
blocked							assembly of foreign
							material. Refer to
							Secion on User
							Maintenance
							Instruction.
Incorrect
Installation							Check the installation to
							ensure the drain hose(s)
							are not kinked.

31