12
Installation instructions
Plumbing -- Water inlet connection
Important!
The appliance should be connected to the water main using the new water inlet hose supplied. Old hoses should not be used.
Do not shorten the inlet hose.
1Take note of water connection requirements.
The dishwasher has a single valve water connection.
We recommend a cold water connection for best performance and energy efficiency. The incoming water temperature should not exceed 60oC.
2Take note of the permitted water pressure extremes.
Lowest: 0.3 bar = 3 N/cm2 = 30kPa
Where pressure is below 1 bar, contact a qualified plumber. Highest: 10 bar = 100 N/cm2 = 1MPa
Where pressure is above 10 bar, a pressure reduction valve must be installed. Contact a qualified plumber.
3Connect the water inlet hose to an accessible water tap with a ¾”BSP connector. Ensure that there is no kink in the inlet hose that could restrict the flow of water. A 90O bend requires a
minimum height of 200 mm for a
Ensure incoming water is clear. If the water pipes have not been used for a long period of time, let the water run to make sure it is clear with no impurities. Not doing so
may result in the water inlet hose getting blocked and damaging the appliance.
If required, use a filter insert to filter out deposits from the piping. The filter insert is available from your Authorised Service Centre or Customer Care.
4Tighten the hose coupling a further half turn after seal contact.
5 Check that the connection does not leak.
min.
10 mm
3/4” BSP connector