20Controls and starting a wash - CC models
CC MODELS
Power/ | Start/Pause | Scroll | Display |
Keylock | Press to start or | Press to navigate | Shows settings, |
| |||
Press briefly to | pause a wash | through menus | options, wash |
power on or off | programme | and options | programme |
or press and hold |
|
| status, |
for 3 seconds to |
|
| fault codes and |
activate/cancel |
|
| instructions |
Keylock |
|
|
|
To start a wash programme
1 Make sure that the dishwasher is powered on .
2Check that the wash programme displayed is the one you would like to use. If not, see section ‘Changing the wash programme.’
3 Once the display shows the programme you would like to use, press to start the programme. The display will show the approximate time remaining and the stage of the wash.
Note: the dishwasher will remember the last programme used.
To pause and restart a wash programme
1 Press to pause the programme.
2Open the door very slowly.
Important!
There is a risk of being sprayed with hot water. Do not fully open the door until the spray arms have stopped rotating.
3Load, remove, or rearrange any dishes if needed.
4Check that there is no excessive steam, then close the door.
Important!
If the programme is paused when the dishwasher has already heated the water, leave the door ajar for several minutes before you close it again; if you don’t, the expanding steam inside could force the door open.
5 Press | to restart the programme. |