Unpacking and Installation Instructions
Unpacking and Examining Your Oven
Remove: all packing materials from inside the oven cavity; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall. Read enclosures and SAVE
this manual.
Check the oven for any damage, such as mis- aligned or bent door,
damaged door seals and
sealing surfaces, broken
or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage,
do not operate the oven and contact your dealer or
DCS AUTHORIZED SERVICER.
Choosing a Location for Your Oven on the counter
You will use the oven frequently so plan its location for ease of use. It’s wise, if possible, to have counter space on at least one side of the oven. Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation.
Choosing a Location for Your Oven if built-in
Your oven can be built into a cabinet or wall by itself or above the models listed below using a DCS by Fisher
&Paykel branded or Fisher & Paykel branded Microwave Accessory Trim Kit (MOTTK). To order the Trim Kit, contact Customer Care.
OVER OVEN INSTALLATION
TOP OF MICRO-
WAVE SHELF
MICROWAVE | 1" |
CUTOUT | (25MM) |
WALL
OVEN CUTOUT
401/4"
(1022MM)
OVER WARMING DRAWER INSTALLATION
TRIM KIT FRAME
ASSEMBLE
OVEN FRONT |
|
Models above which the |
|
microwave oven can be built in: |
|
Ovens: |
|
| |
OB30SDEPX (Fisher & Paykel) |
|
Warming drawers: |
|
| |
| |
OD30WDX1 (Fisher & Paykel) |
|
Do not build in above any other gas | 4 |
or electric wall oven. |
MICROWAVE | 2" |
CUTOUT | (51MM) |
WARMING
DRAWER
CUTOUT
RECOMMENDED HEIGHT 36" (914MM)
See Trim Kit Installation Instructions for proper location when building in above the specified wall ovens. Care- fully follow both the wall oven installation instructions and Trim Kit instructions.
The opening in the wall or cabinet must be within the following dimensions:
A | HEIGHT | : | 17" + 1/16", |
B | WIDTH | : | 24 3/4" + 1/16", |
C | DEPTH | : | minimum 20" |