2
LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE
SAFETY DEVICE (Dual burners)
In order to light the burner, you must:
1.Push and turn the dial in an 
(maximum rate of inner + outer crown); push in and hold the dial until the flame has been lit (fig. 2.4).
The sparks produced by the lighter situated inside the relative burner will light the flame.
In the event that the local gas supply conditions makes it difficult to light the burner
in position 
, try again with the dial in position 
.
2.Wait for about ten seconds after the gas burner has been lit before letting go the dial (safety device activation delay).
3.Adjust the gas valve to the desired position.
If there is no mains electrical supply, the burners can be used with no restriction. In that case, in order to light the burner, you must:
1. Bring a lighted match close to the burner (as per side figure) and keep it in place until the burner has been ignited.
2. Push and turn the dial in an 
(maximum rate of inner + outer crown); push in and hold the dial until the flame has been lit (fig. 2.4).
In the event that the local gas supply conditions makes it difficult to light the burner
in position 
, try again with the dial in position 
.
3.Wait for about ten seconds after the gas burner has been lit before letting go the dial (safety device activation delay).
4.Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.
To
If your local gas supply makes it difficult to light the burner with the dial set to maximum, set the dial to minimum and repeat the operation.
N.B. When the cooker is not being used, set the gas dials to their OFF positions and also close the gas
Caution!
The cooker becomes very hot during operation.
Keep children well out of reach.
13
